3” diameter port (for connecting drying accessories)

Displays collector temperature, vacuum level, and optional End-Zone™ end point detection system in real time

Modes: Collector cool-down (start-up) and vacuum pull-down (automatic or manual)

Operating mode (standby or run)

Settings: multi-language, time, time zone, temperature (° C or ° F), and vacuum (mBar, Torr, or Pa)

Vacuum set point, alerts, diagnostic tests, user manual, defrost control, and optional drying accessory parameters

Data logging storage and display: table or chart format exportable via USB or Ethernet

Programmable alerts can be sent via Ethernet connection to user-entered email addresses.

Display settings: brightness, touch sounds (on/off), and screen time out in minutes (on/off)

Maintenance alert settings include vacuum pump oil change, refrigeration cleaning, total operating hours and line voltage offset

Level-specific security lock-out prevents changes to programs and other system parameters

Hot gas defrost with auto shut off at +65° C (+149° F)

On/standby switch

Moisture sensor prevents refrigeration or vacuum start-up when moisture is detected in the drain line

USB port (side-mounted) and Ethernet connection (rear-mounted)

Side-mounted, quick-disconnect drain hose fitting and lanyard with hose connector

Rear-mounted electrical receptacle for vacuum pump connection

Includes: 18", 1/4" ID silicone tubing and clamp, 3-wire electrical cord with plug

3/4" OD vacuum connection, 50" of 3/4" ID vacuum hose and two clamps

Vacuum control valve maintains vacuum level set point

Vacuum break valve bleeds air into the system in event of power outage

Learn More: FreeZone 2.5